Engine Mechanical:
Complete overhaul, timing, seals, gaskets, cooling system, lubrication system
Engine Control:
ECM, sensors, actuators, diagnostics, emissions control
Fuel System:
Fuel pump, injectors, lines, pressure, filters, specifications
Ignition Starting Charging:
Spark plugs, coils, alternator, starter, battery, wiring schematics
Automatic Transmission:
Diagnosis, repair, fluid specifications, internal components, control systems
Manual Transmission:
Diagnosis, repair, clutch, fluid specifications, internal components
Drivetrain:
Transfer case, propeller shaft, drive shafts, differentials, axle assemblies
Suspension:
Front and rear suspension components, alignment, specifications
Wheels Tires:
Tire pressure, rotation, wheel specifications, bolt patterns
Brake System:
Hydraulic system, ABS, EBD, brake pads, rotors, calipers, parking brake
Steering:
Steering column, power steering system, rack and pinion, specifications
HVAC:
Air conditioning system, heater, climate control, components, refrigerant
Safety Restraint System:
Airbags, seat belts, SRS module, diagnosis
Body Exterior:
Hood, doors, panels, bumpers, glass, mirrors
Body Interior:
Seats, instrument panel, trim, door locks, console
Electrical System:
Wiring schematics, circuits, lighting, horn, wipers, washers
Multiplex Can Communication:
CAN bus system, network diagnostics, modules
Infotainment Audio:
Audio system, speakers, Uconnect (if applicable), meter/visual systems
Cruise Control:
Operation, diagnosis, components
Immobilizer:
Engine immobilizer system operation and diagnosis
Maintenance Procedures:
Scheduled maintenance, fluid changes, filter replacements, inspections
Diagnostic Procedures:
Troubleshooting flowcharts, DTC interpretation, symptom analysis
Repair Procedures:
Step-by-step instructions for component removal, installation, and overhaul
Adjustment Procedures:
Wheel alignment, brake adjustments, clutch adjustments
Calibration Procedures:
System calibrations after component replacement (e.g., ABS sensors)
Wiring Schematic Interpretation:
Detailed wiring diagrams for all vehicle electrical systems
Depth:
Factory-level technical detail for dealership technicians
Diagnostic Capabilities:
Advanced diagnostics, including subsystem interactions and electronic control module (ECM) analysis
Rebuild Instructions:
Comprehensive instructions for engine and transmission rebuilds
Oil Change Interval:
Typically every 5,000 - 7,500 miles (8,000 - 12,000 km) or as indicated by oil change indicator
Air Filter Replacement:
Check at 15,000 miles (24,000 km), replace as needed
Coolant Flush:
First flush at 60,000 miles (96,000 km), then every 30,000 miles (48,000 km)
Engine Oil Specification:
SAE 5W-20 (API SN or newer, Chrysler MS-6395)
Automatic Transmission Fluid Specification:
ATF+4 (Chrysler MS-9602)
Brake Fluid Specification:
DOT 3
Common Issues Examples:
Water pump leaks, potential transmission shift issues, occasional electrical gremlins, carbon buildup on valves (direct injection engines, though less prevalent on early models)
