Engine Type:
        
        
            2-Stroke Outboard Motor
        
     
    
    
        
            Horsepower Range:
        
        
            2.2 HP to 40 HP
        
     
    
    
        
            Engine Cylinders:
        
        
            Variable (Details differ by model)
        
     
    
        
            Total Displacement:
        
        
            Variable (Details differ by model)
        
     
    
    
        
            Fuel Supply System:
        
        
            Carburetor or Multi-point sequential electronic fuel injection (EFI)
        
     
    
    
        
            Cooling System:
        
        
            Water Cooled
        
     
    
    
        
            Lubrication System:
        
        
            Wet Sump
        
     
    
    
        
            Ignition Type:
        
        
            Details vary, includes spark plug, charge coil, crank position sensor, ignition coil, ECM
        
     
 
    
    
        
        Intervals Recommendations
    
 
    
        
            Maintenance Schedule:
        
        
            Recommended for peak operating condition and compensating for wear
        
     
    
    
        
            Gear Oil Capacity:
        
        
            Variable in ml (Details differ by model)
        
     
    
    
        
            Gear Oil Type:
        
        
            Outboard Motor Gear Oil
        
     
    
    
        
            Spark Plug Recommendations:
        
        
            Specifics found within the manual
        
     
    
        
            Idle Speed:
        
        
            Specific RPMs for various conditions (e.g., out of gear, in forward gear, WOT)
        
     
 
    
    
    
        
            Sections Covered:
        
        
            Specifications, Maintenance, General Information, Electrical, Ignition, Carburetor, EFI System, Powerhead, Mid-Section, Lower Unit, Attachments/Control Linkage, Throttle/Shift Linkage, Tiller Handle, Manual Starter, Diagnostic Troubleshooting, Wiring Diagrams
        
     
    
    
        
            Powerhead Procedures:
        
        
            Complete rebuild, removal, inspection, installation of cylinder head, crankshaft, pistons, etc.
        
     
    
        
            Lower Unit Procedures:
        
        
            Gear case, gears, shimming, drive shaft, water pump, shift guide housing, propeller shaft
        
     
    
        
            Ignition System Coverage:
        
        
            Specifications, special tools, timing, charge coil resistance, crank position sensor resistance, ignition coil resistance, ECM functions
        
     
    
        
            Carburetor Coverage:
        
        
            Adjustment, rebuild, removal, inspection, cleaning, linkage, choke, float height, idle RPM, WOT RPM
        
     
    
        
            Electrical System Coverage:
        
        
            Starter motor, electric starter system, battery charging system (coil, rectifier/regulator), monitor tachometer