Engine Mechanical:
Engine Overhaul, Cylinder Head, Block, Pistons, Crankshaft, Camshaft, Valves, Timing
Fuel System:
Fuel Pumps, Carburetors (e.g., Solex, Zenith), Fuel Injection Systems (e.g., Bosch D-Jetronic for some W114 models), Fuel Tank, Lines, Filters, Specifications
Ignition System:
Distributor, Spark Plugs, Coils, Ignition Timing, Condenser, Points (where applicable), Electronic Ignition
Cooling System:
Radiator, Water Pump, Thermostat, Hoses, Coolant Specifications, Fan Clutch
Lubrication System:
Oil Pump, Oil Filter, Oil Pan, Oil Viscosity Specifications, Oil Change Intervals
Emission Control:
Emission Control Systems specific to 1975, EGR (Exhaust Gas Recirculation), Air Injection, Fuel Evaporative Emission Control
Intake Exhaust:
Intake Manifold, Exhaust Manifold, Mufflers, Catalytic Converter (if equipped), Emissions related
Transmission Manual:
Clutch System, Manual Gearbox Overhaul, Gear Ratios, Shift Linkage, Fluid Specifications
Transmission Automatic:
Automatic Transmission (e.g., 3-speed or 4-speed) Overhaul, Valve Body, Torque Converter, Fluid Type and Capacity, Shift Control
Drive Axle Differential:
Rear Axle Housing, Differential Gear Assembly, Axle Shafts, Fluid Specifications, Wheel Bearings
Suspension Front:
Independent Front Suspension, Control Arms, Ball Joints, Bushings, Springs, Shock Absorbers, Wheel Alignment Specifications
Suspension Rear:
Rear Axle, Suspension Arms, Bushings, Springs, Shock Absorbers, Wheel Alignment Specifications
Steering:
Steering Column, Steering Gearbox (e.g., Recirculating Ball), Power Steering System (if equipped), Steering Linkage, Fluid Specifications
Brakes Hydraulic:
Brake System Diagnosis, Master Cylinder, Wheel Cylinders, Calipers, Brake Pads, Brake Shoes, Brake Fluid Specifications, Bleeding Procedures
Brakes Parking:
Parking Brake Mechanism, Cables, Adjustment Procedures
Wheels Tires:
Tire Size Specifications, Inflation Pressures, Wheel Torque Specifications, Bolt Patterns
Electrical System:
Battery, Alternator, Starter Motor, Wiring Harnesses, Fuses, Relays, Lighting System, Horn
Instrumentation:
Instrument Cluster Diagnosis and Repair, Gauges (Speedometer, Tachometer, Fuel, Temperature), Warning Lights
Climate Control:
Air Conditioning System (if equipped), Heater Core, Blower Motor, Controls, Refrigerant Specifications and Procedures
Body Exterior:
Doors, Hood, Trunk Lid, Bumpers, Grille, Exterior Trim, Glass Replacement, Seals
Body Interior:
Seats, Upholstery, Dashboard, Trim Panels, Interior Lighting, Door Hardware
Wipers Washers:
Wiper Motor, Linkage, Blades, Washer Pump, Fluid Reservoir
Safety Restraint:
Seat Belts, Retractor Mechanisms, (Note: Supplemental Restraint Systems like airbags were not common in 1975)
Cruise Control:
Cruise Control System Diagnosis and Repair (if equipped)
Lighting:
Headlights, Taillights, Turn Signals, Interior Lights, Wiring Schematics for Lighting
Multiplex Can Communication:
Not applicable for 1975 models. This likely refers to modern manual features.
Maintenance Procedures:
Oil Changes, Filter Replacements, Spark Plug Service, Fluid Checks and Replacements, Lubrication Points, Belt Adjustments
Diagnostic Procedures:
Troubleshooting Guides for various systems, identifying common faults, symptom-based diagnosis
Repair Procedures:
Step-by-step instructions for component removal, disassembly, inspection, repair, reassembly, and installation
Rebuild Procedures:
Complete rebuilds for engines, transmissions, carburetors, and other major components
Adjustment Procedures:
Carburetor idle/mixture adjustments, ignition timing, valve clearance (if applicable), parking brake adjustment, clutch adjustment
Wiring Schematics:
Detailed electrical wiring diagrams for all vehicle systems
Depth:
Factory level, highly detailed, covering basic to advanced repairs and diagnostics
Illustration Quality:
Diagrams, illustrations, and schematics
Oil Change Interval:
Typically every 5,000-7,500 km (3,000-5,000 miles) or 6-12 months, depending on oil type and driving conditions.
Tune Up Interval:
Ignition points and condenser replacement, spark plug service, and carburetor adjustment typically every 10,000-20,000 km (6,000-12,000 miles).
Transmission Fluid Change:
Automatic transmission fluid and filter replacement typically every 30,000-50,000 km (18,000-30,000 miles).
Engine Oil:
API SF or SG grade, viscosity dependent on climate (e.g., 10W-40, 15W-50). Check manual for exact recommendations.
Transmission Fluid Auto:
Dexron II or equivalent (for older automatics), consult manual for exact specification.
Brake Fluid:
DOT 3 or DOT 4.
Coolant:
Ethylene glycol based antifreeze, mixed 50/50 with distilled water. Mercedes-specific coolant may be recommended.
Common Issue 1:
Carburetor performance and tuning issues (wear, vacuum leaks).
Common Issue 2:
Age-related wear in suspension bushings and steering components.
Common Issue 3:
Electrical issues related to aging wiring insulation, grounds, and component failures.
Common Issue 4:
Rust and corrosion, particularly in common areas like wheel wells, sills, and around windows.
Common Issue 5:
Vacuum leaks affecting engine performance and idle control.
Common Issue 6:
Fuel system components deterioration (rubber hoses, seals) due to age and fuel composition changes.