Engine Mechanical:
Full disassembly, inspection, and reassembly of engine components, including cylinder heads, pistons, crankshaft, camshafts, timing systems, and lubrication.
Engine Electrical:
Starting and charging systems, ignition system, fuel injection system diagnostics, sensors, actuators, powertrain control module (PCM) functions, and wiring diagrams.
Emission Control:
On-Board Diagnostics (OBD-II) system, evaporative emission control (EVAP), catalytic converter operation, oxygen sensors, and emissions testing procedures.
Fuel System:
Fuel delivery, fuel pump, fuel filter replacement, fuel injectors, fuel pressure testing, and diagnosis of fuel system faults.
Clutch System:
If equipped with manual transmission, clutch inspection, adjustment, and replacement.
Manual Transaxle:
If equipped with manual transmission, complete overhaul, fluid changes, internal component repair, and diagnostic procedures.
Automatic Transaxle:
Complete diagnostic procedures, fluid and filter changes, valve body service, torque converter replacement, and full transmission rebuild for various automatic transmission models.
Driveshaft Axle:
Inspection, repair, and replacement of driveshafts, CV joints, axles, and differential components.
Suspension System:
Front and rear suspension components, shock absorbers, struts, springs, control arms, ball joints, bushings, and alignment procedures.
Steering System:
Power steering system diagnosis and repair, steering rack, tie rod ends, steering column, and hydraulic components.
Restraint System:
Airbag system diagnosis, component replacement (SRS modules, sensors, airbags), seatbelt repair, and related electrical systems.
Brake System:
Brake fluid flush and bleed, disc brake pad and rotor replacement, caliper service, ABS system diagnostics, parking brake adjustment and repair.
Body Interior Exterior:
Body panel repair, door panel removal and installation, interior trim, upholstery, glass replacement, bumpers, and aerodynamic components.
Body Electrical System:
Lighting systems (headlights, taillights, interior lights), power windows, power locks, mirrors, wipers, horn, and body control module (BCM) functions.
Heating Ventilation Air Conditioning:
HVAC system diagnosis, refrigerant recharge, A/C compressor replacement, blower motor service, cabin air filter replacement, and climate control panel operation.
Maintenance:
Oil changes, filter replacements (oil, air, fuel, cabin), fluid level checks and top-offs, lubrication points, tire rotation.
Troubleshooting:
Diagnostic trouble codes (DTCs), symptom-based troubleshooting guides, electrical schematic interpretation, and pinpoint tests.
Repair:
Component replacement, system overhauls, seal and gasket replacements, wiring harness repair, and adjustment procedures.
Rebuilding:
Complete engine, transmission, and differential rebuilding procedures, including part specifications and tolerances.
Depth:
Comprehensive, covering everything from basic DIY tasks to advanced dealership-level repairs and diagnostics.
Oil Change Interval:
Typically every 7,500 miles or 6 months, or as indicated by the Oil Life Monitoring System. Consult manual for specific recommendations.
Transmission Fluid Change:
Recommended every 45,000 - 100,000 miles depending on driving conditions (severe vs. normal). Refer to the manual for precise intervals and procedures.
Coolant Flush:
Typically recommended around 100,000 miles or 5 years for the initial service, then every 45,000-100,000 miles thereafter, depending on coolant type. Check manual for specific DEX-COOL or other coolant specifications.
Engine Oil Spec:
Typically SAE 5W-30 synthetic blend or full synthetic oil, meeting GM specification (e.g., GM6094M or dexos-approved for later models). Check manual for exact specification and viscosity grade.
Brake Fluid Spec:
DOT 3 or DOT 4 brake fluid. Always use fresh, sealed fluid. Consult manual for precise specification.
Transmission Hard Shifting:
Some 4L60-E transmissions may exhibit hard shifting or delayed engagement, often related to solenoid issues or internal wear. The manual provides diagnostic steps.
Fuel Pump Module:
Potential for fuel pump module failure or fuel level sending unit inaccuracies. The manual details fuel system diagnostics.
Exhaust Manifold Cracks:
Certain engine configurations, particularly early models, could be prone to exhaust manifold cracks, leading to exhaust leaks and ticking noises. Manual covers inspection and repair.