Engine Mechanical:
Cylinder head, pistons, crankshaft, connecting rods, lubrication, valve train, timing
Engine Management:
Fuel injection, ignition system, ECU (Engine Control Unit) diagnostics, sensors, actuators
Transmission Mechanical:
Clutch operation, gear selection, internal gearbox components, final drive
Chassis And Frame:
Frame inspection, welding, alignment, steering system, front forks
Suspension System:
Front fork service and overhaul, rear shock absorber adjustment and replacement, linkage maintenance
Wheel And Tire System:
Wheel bearing service, tire pressure recommendations, wheel balancing
Braking System Front:
Brake caliper service, master cylinder overhaul, brake disc inspection and replacement, pad replacement
Braking System Rear:
Rear brake caliper service, master cylinder overhaul, brake disc inspection and replacement, pad replacement
Cooling System:
Radiator service, coolant replacement, water pump inspection, thermostat operation
Exhaust System:
Muffler and pipe inspection, gasket replacement, mounting hardware
Electrical System Lighting:
Headlight, taillight, turn signal, brake light bulb types and replacement
Electrical System Ignition:
Spark plug specification and replacement, ignition coil testing
Electrical System Starting Charging:
Starter motor service, alternator testing, battery maintenance and testing
Electrical System Wiring Diagrams:
Comprehensive wiring schematics for all circuits
Bodywork And Fairings:
Panel removal and installation, fairing repair, seat replacement
Controls And Cables:
Throttle cable adjustment, clutch cable adjustment, brake lever service
Routine Maintenance:
Oil changes, filter replacements, chain adjustment, brake fluid flush, coolant flush
Major Engine Repairs:
Engine rebuilds, piston ring replacement, valve seat grinding, head gasket replacement
Transmission Overhaul:
Complete gearbox disassembly, inspection, and reassembly
Suspension Rebuild:
Front fork seal replacement, damper rebuilding, shock absorber service
Brake System Overhaul:
Caliper piston seal replacement, master cylinder rebuild, bleeding procedures
Electrical Troubleshooting:
Fault finding using diagnostic charts and wiring diagrams
Fuel System Diagnostics:
Fuel pump testing, injector cleaning and testing, carburetor (if applicable) adjustment
Carburetor Synchronization:
Detailed steps for balancing carburetor air/fuel mixtures
Body Panel Alignment:
Guidance on fitting and aligning fairings and covers
Diagnostic Codes:
Listing and interpretation of error codes (if applicable to the model's ECU)
Depth:
Extensive, covering all aspects from basic maintenance to complete engine and transmission rebuilds
Detail Level:
Detailed step-by-step instructions, torque specifications, special tool requirements
Engine Type:
90-degree V-twin, four-stroke
Displacement:
996 cc (996 cubic centimeters)
Bore X Stroke:
98 mm x 66 mm (approximate)
Valve Train:
DOHC (Dual Overhead Camshafts), 4 valves per cylinder
Cooling System:
Liquid-cooled
Horsepower:
Approx. 125-130 hp @ 9000 rpm (depending on model year and tuning)
Torque:
Approx. 98-100 Nm (72-74 lb-ft) @ 7000 rpm (depending on model year and tuning)
Fuel Delivery:
Electronic Fuel Injection (EFI) - likely throttle body injection (TBI) or multi-point injection (MPI) depending on year
Fuel Type:
Unleaded gasoline (Octane rating typically 95 RON or higher)
Ignition Type:
Digital CDI (Capacitor Discharge Ignition)
Configuration:
2-into-1 or 2-into-2 underseat exhaust system
Safety Ratings:
N/A (Motorcycle safety ratings are generally not standardized in the same way as cars)
Braking System Type:
Dual front disc brakes, single rear disc brake
Front Brake Specifications:
Dual 320 mm discs, radial-mount calipers (typically Brembo)
Rear Brake Specifications:
Single 220 mm disc, 2-piston caliper
Suspension Front:
Inverted telescopic forks (adjustable preload, compression, rebound)
Suspension Rear:
Monoshock with linkage (adjustable preload, compression, rebound)
Frame Type:
Aluminum twin-spar frame
Lighting System:
Halogen headlamp, LED taillight (on some later models)
Engine Oil Change:
Every 6,000 km (3,700 miles) or 6 months, whichever comes first.
Oil Filter Replacement:
Every 6,000 km (3,700 miles) or 6 months, with oil change.
Spark Plug Replacement:
Every 12,000 km (7,500 miles) or 12 months.
Air Filter Cleaning Replacement:
Inspect every 6,000 km (3,700 miles), clean/replace as needed. Replace every 18,000 km (11,200 miles).
Coolant Replacement:
Every 24,000 km (15,000 miles) or 24 months.
Brake Fluid Flush:
Every 12,000 km (7,500 miles) or 12 months.
Chain Lubrication Adjustment:
Inspect and lubricate every 1,000 km (600 miles).
Engine Oil Type:
API SG or higher, JASO MA certified, SAE 10W-40 or 20W-50 (refer to manual for ambient temperature specific recommendations)
Coolant Type:
Permanent type antifreeze coolant (ethylene glycol based), 50/50 mix with distilled water
Clutch Fluid Type:
DOT 4 (same as brake fluid)
Electrical Gremlins:
Some owners report occasional electrical connector issues or rectifier/regulator failures.
Cam Chain Tensioner:
Potential for wear or failure of automatic cam chain tensioners (can lead to rattling noise).
Fuel Pump Reliability:
Early models might have had some fuel pump reliability concerns, often addressed with upgrades.
Suspension Tuning:
While adjustable, finding the optimal suspension setup can require experimentation.
