Engine Mechanical:
Engine assembly, cylinder head, block, pistons, crankshaft, camshaft, timing, lubrication system, cooling system, fuel delivery, ignition system (mechanical aspects).
Engine Electrical:
Engine control module (ECM), sensors (crankshaft position, camshaft position, O2, MAP, etc.), ignition coils, fuel injectors, wiring diagrams.
Transmission:
Manual transmission (Getrag NV1500, Getrag Getrag MT285), Continuously Variable Transmission (CVT - Jatco JF011E), clutch system, torque converter, transmission control module (TCM), fluid specifications.
Brakes:
Hydraulic system, master cylinder, brake boosters, calipers, rotors, pads, Anti-lock Braking System (ABS) components and diagnosis, parking brake.
Suspension:
Front suspension (struts, control arms, ball joints, sway bar), rear suspension (torsion beam axle, trailing arms, shocks), wheel bearings, alignment specifications.
Steering:
Power steering system (hydraulic and electric depending on model), steering column, steering gear, tie rods, power steering fluid specifications.
Electrical System:
Battery, charging system (alternator), starting system (starter motor), lighting (headlights, taillights, interior), power windows, power locks, wipers, horn, fuses, relays, body control module (BCM).
HVAC:
Air conditioning system (compressor, condenser, evaporator, refrigerant, refrigerant type R-134a), heating system, blower motor, climate controls, cabin air filter replacement.
Body And Chassis:
Body panels, doors, hood, liftgate, bumpers, interior trim, underbody components, corrosion protection, structural integrity.
Safety Systems:
Airbag system (SRS - Supplemental Restraint System) components, sensors, control module, seat belts.
Routine Maintenance:
Oil change intervals, oil filter replacement, air filter replacement, cabin air filter replacement, spark plug replacement, coolant flush and replacement, brake fluid flush and replacement, transmission fluid change.
Engine Repair:
Engine diagnostics, cylinder head removal and installation, piston and ring replacement, crankshaft and bearing replacement, camshaft and timing chain/belt service, valve adjustment (if applicable).
Transmission Repair:
Manual transmission overhaul, CVT fluid and filter replacement, torque converter removal and installation, transmission mount replacement.
Brake Repair:
Brake pad and rotor replacement, caliper overhaul, brake bleeding, ABS sensor replacement, parking brake adjustment.
Suspension And Steering Repair:
Strut and shock replacement, control arm and ball joint replacement, wheel bearing replacement, power steering pump or motor replacement, tie rod end replacement.
Electrical Diagnostics:
Troubleshooting electrical faults using diagnostic trouble codes (DTCs), wiring diagram interpretation, component testing, ECU/BCM diagnostics.
HVAC Service:
Refrigerant system evacuation and recharge, component replacement (compressor, condenser, evaporator), leak detection, blower motor replacement.
Bodywork And Trim:
Door panel removal, interior trim panel replacement, liftgate adjustment, minor body panel repair procedures.
Diagnostics And Troubleshooting:
System-specific diagnostic flowcharts, common symptom analysis, fault code interpretation, recommended diagnostic tools.
Depth:
Comprehensive, covering everything from basic maintenance and fluid changes to complex engine and transmission overhauls, electrical diagnostics, and system troubleshooting. Suitable for professional mechanics and advanced DIY enthusiasts.
Oil Change Interval:
Every 3,000-5,000 miles (5,000-8,000 km) under normal conditions, or as indicated by the oil change reminder system. Refer to manual for severe service intervals.
Air Filter Replacement:
Every 15,000-30,000 miles (24,000-48,000 km), or as needed based on driving conditions.
Cabin Air Filter Replacement:
Every 10,000-15,000 miles (16,000-24,000 km), or annually.
Spark Plug Replacement:
Around 60,000-100,000 miles (96,000-160,000 km), depending on plug type (e.g., platinum or iridium).
Coolant Replacement:
Initial replacement at 60,000 miles (96,000 km), then every 30,000 miles (48,000 km) or 2 years thereafter.
Engine Oil Type:
SAE 5W-20 (meeting Chrysler Material Standard MS-6395).
Engine Oil Capacity:
4.5 quarts (4.3 liters) for 2.0L; 5.0 quarts (4.7 liters) for 2.4L (with filter).
Coolant Type:
Mopar OAT (Orange) Antifreeze/Engine Coolant (50/50 mixture with distilled water).
Transmission Fluid Manual:
API GL-4 SAE 75W-85 (Getrag NV1500); API GL-4 SAE 75W-90 (Getrag MT285). Consult manual for specific OEM part numbers.
Transmission Fluid Cvt:
Mopar CVT Fluid (NS-2 or NS-3 equivalent). Consult manual for exact specification and capacity. DO NOT use conventional ATF.
Power Steering Fluid:
Mopar Power Steering Fluid or equivalent. (Note: Some models may have electric power steering which does not require fluid).
Cvt Issues:
Some CVT models have reported issues with premature failure, hesitation, or shuddering. Proper fluid maintenance is critical.
Engine Mounts:
Worn engine mounts can lead to increased vibration and noise.
Suspension Components:
Reports of premature wear in front suspension components like control arms and struts.
Ignition Coils:
Occasional reports of ignition coil failure leading to misfires.