Engine Service Repair:
Detailed engine overhaul, diagnostics, and repair procedures
Transmission Service Repair:
Manual and automatic transmission service, repair, and overhaul
Brake System:
Front and rear brake systems, including discs, drums, hydraulic lines, and ABS (if applicable)
Wiring Diagram:
Comprehensive electrical wiring diagrams for all vehicle systems
Electrical System:
Detailed coverage of starting, charging, lighting, ignition, and accessory systems
Suspension:
Front and rear suspension components, alignment, and repair procedures
Steering:
Power steering system, steering rack, and linkage repair
Cooling System:
Radiator, thermostat, water pump, and coolant flow diagnostics
Fuel Injection:
Fuel injection system components, diagnostics, and calibration
Fuel System:
Fuel pump, tank, lines, and filter service
Emission System:
Emissions control devices, diagnosis, and repair
Heater Air Conditional:
HVAC system diagnosis and repair, including refrigerant servicing
Engine Control System:
ECU, sensors, actuators, and diagnostic trouble codes (DTCs)
Chassis Body:
Body structure, panels, doors, and chassis components
Restraint System:
Seat belts, airbags (if applicable), and associated systems
Interior:
Interior trim, seats, dashboard, and console removal/installation
Differential Drive:
Front-wheel drive axle and differential service
Axle:
Front axle and drive shaft components
General Maintenance:
Routine checks, fluid changes, filter replacements, and adjustments
Troubleshooting:
Diagnostic charts and procedures for identifying and resolving common faults
Periodic Lubrication:
Lubrication points and recommended service intervals
Exhaust System:
Component identification, inspection, and replacement of exhaust pipes, muffler, and catalytic converter.
Wheels Tires:
Tire rotation, balancing, inspection, and wheel mounting procedures. Bolt pattern: 4x100mm.
Lighting System:
Headlights, taillights, interior lighting, bulb replacement, and circuit diagnostics.
Engine Control Module:
ECM/ECU functions, sensor inputs (MAP, TPS, O2), actuator outputs (injectors, ignition coils), and diagnostic procedures.
Diagnostic Procedures:
System-specific diagnostic trees, symptom-based troubleshooting
Repair Procedures:
Step-by-step instructions for component removal, repair, and reinstallation
Maintenance Procedures:
Scheduled maintenance tasks and roadside checks
Technical Data:
Specifications, torque values, clearances, and tolerances
Engine Overhaul:
Complete engine teardown, cleaning, inspection, measurement, and reassembly with specifications.
Brake Bleeding:
Detailed procedures for bleeding the hydraulic brake system.
Diagnostics Troubleshooting Charts:
Flowcharts and tables to systematically diagnose problems based on symptoms.
Ignition System Repair:
Ignition timing adjustment, distributor service, spark plug replacement, ignition coil testing.
Wheel Alignment Specs:
Camber, caster, toe-in specifications for front and rear axles.
Depth:
Comprehensive factory-level detail suitable for professional technicians and advanced DIY users
Diagnostic Tools:
Mentions specific diagnostic tools or procedures, e.g., timing light, multimeter usage, sometimes basic scan tool references for EFI models.
Oil Change Interval:
Typically every 5,000-7,500 miles or 6-12 months, depending on driving conditions. Specifics in manual.
Engine Oil Type:
API SG/SH rated SAE 10W-30 or 10W-40. Check manual for exact viscosity and capacity.
Coolant Type:
Ethylene glycol based coolant, typically a 50/50 mix with distilled water. Mazda FL22 or equivalent may be specified for later models but this era likely uses standard green coolant.
Brake Fluid Type:
DOT 3 or DOT 4 brake fluid. Refer to manual for precise specification.
Power Steering Fluid Type:
If equipped with power steering, usually ATF Dexron II or equivalent. Check manual.
Common Problems:
Rust, especially on wheel arches and sills; minor electrical gremlins; clutch wear; carburetor issues on non-EFI models.
Maintenance Schedule Details
Major Service Items:
Spark plugs, fuel filter, air filter, timing belt (if applicable and not a chain), coolant flush, transmission fluid change.
