Engine:
Complete Engine Overhaul, Diagnostics, and Repair
Cooling System:
Radiator, Fan, Water Pump, Thermostat, Hoses, and Coolant
Fuel System:
Fuel Injection Pump, Injectors, Fuel Lines, Filters, and Tank
Power Train:
Including transmission, final drives, axles, and driveline components
Transmission:
Gearbox, clutch, shifting mechanisms, and related components
Front Axle:
Steering components, kingpins, bearings, and seals
Rear Axle:
Differential, axle shafts, bearings, and housings
Clutch:
Clutch assembly, linkage, and operation
Differential Lock:
Operation, adjustment, and repair
Electrical System:
Wiring diagrams, starter, alternator, battery, lighting, and gauges
Brakes:
Brake system components, hydraulics, and adjustments
Fenders Fuel Tank Platform:
Body panels, fuel tank, and operator platform
Final Drive:
Components and service procedures
Front System:
General front-end components and service
Front Wheel Drive:
FWD axle, driveshaft, and related components (if applicable)
Hydraulic System:
Hydraulic pump, valves, cylinders, filters, and fluid
Main Drive Bevel Gears And Differential:
Service and repair for drive gears and differential
Park Brake:
Operation and maintenance
Power Steering System:
Hydraulic steering components, pump, and linkages
Power Take Off:
PTO shaft, engagement, and service
Steering Gear:
Components and service procedures
General Maintenance:
Lubrication, fluid changes, filter replacements, and adjustments
Troubleshooting:
Diagnostic charts, common problems, and repair solutions
Repair Procedures:
Step-by-step instructions for disassembly, assembly, and component replacement
Overhaul Instructions:
Complete engine and transmission rebuild procedures
Electrical Diagnostics:
Troubleshooting electrical faults using wiring diagrams
Hydraulic Diagnostics:
Troubleshooting hydraulic system issues
Calibration And Adjustment:
Procedures for aligning and adjusting various systems
Depth:
Complete factory service and repair information, suitable for DIY and experienced mechanics.
Engine Oil Change:
Typically 250-500 operating hours; consult manual for exact interval and oil type.
Transmission Fluid Change:
Typically 1000-2000 operating hours; consult manual for fluid type and capacity.
Engine Oil:
API CG-4 or CH-4, SAE 15W-40 diesel engine oil is common; consult manual for specific viscosity and API rating.
Hydraulic Fluid:
UTTO (Universal Tractor Transmission Oil) or specific Case IH fluid; consult manual for specifications and capacity.
Coolant:
Ethylene glycol based antifreeze with corrosion inhibitors, typically a 50/50 mix with distilled water. Consult manual for type and capacity.
Common Wear Points:
Clutch wear, hydraulic seal leaks, PTO bearing wear, and front axle kingpin wear are common on older tractors.