Engine:
Complete overhaul, diagnostics, timing, fuel system, lubrication, cooling
Transmission:
Gearbox, clutch, power take-off (PTO), differential, final drives, hydraulic transmission (if applicable)
Hydraulics:
Hydraulic pump, control valves, cylinders, linkages, hydraulic oil specifications and maintenance
Electrical System:
Wiring diagrams, starter motor, alternator, battery, lighting, instrumentation, ignition system (if applicable)
Brakes:
Brake system inspection, repair, adjustments, fluid specifications
Steering:
Steering mechanism, linkages, power steering system (if equipped)
Front Axle:
Front axle assembly, kingpins, steering knuckles, wheel bearings
Rear Axle:
Rear axle housing, drive shafts, differential, wheel hubs
Cooling System:
Radiator, fan, thermostat, water pump, coolant specifications and service
Fuel System:
Fuel tank, lines, filters, injection pump, injectors, diesel fuel specifications
Exhaust System:
Exhaust manifold, pipes, muffler inspection and replacement
Bodywork:
Sheet metal, fenders, operator platform, controls, cab (if equipped)
Engine Overhaul:
Complete engine disassembly, inspection, component replacement, and reassembly procedures
Transmission Repair:
Gearbox, clutch, and PTO repair and adjustment
Hydraulic System Service:
Pump replacement, valve adjustments, cylinder seal replacement, troubleshooting hydraulic issues
Electrical Troubleshooting:
Diagnosis and repair of electrical faults using wiring diagrams
Brake Adjustment:
Procedure for adjusting mechanical or hydraulic brakes
Front Rear Axle Rebuild:
Service and overhaul procedures for front and rear axle assemblies
Cooling System Maintenance:
Flushing, coolant replacement, and component checks
Fuel Injection System Maintenance:
Injector testing, pump timing, and filter replacement
Pto Service:
Power Take-Off unit maintenance and repair
Troubleshooting Guides:
Systematic troubleshooting steps for common problems
Lubrication Charts:
Detailed lubrication points and recommended lubricants
Depth Of Coverage:
Full workshop level, covering diagnostics, repair, and overhaul
Diagnostic Procedures:
Detailed diagnostic flowcharts and symptom-based troubleshooting
Torque Specifications:
Precise torque values for all critical fasteners
Schematics:
Detailed electrical wiring diagrams and hydraulic schematics
Special Tools:
Identification and use of specialized tools required for specific repairs
Engine Oil Change:
Typically every 250-500 operating hours (refer to manual for specific interval and oil type)
Air Filter Maintenance:
Regular inspection and cleaning/replacement based on operating conditions
Fuel Filter Replacement:
Scheduled replacement every 500-1000 operating hours or as per manual recommendations
Hydraulic Oil Change:
Typically every 1000-1500 operating hours
Engine Oil Type:
API CD or CE grade diesel engine oil, SAE 15W-40 or 10W-30 depending on climate (refer to manual)
Hydraulic Oil Type:
Tractor Hydraulic Fluid (THF), UTF (Universal Tractor Transmission Oil), or specific Fiat-approved hydraulic oil (e.g., Fiat Type A or similar)
Transmission Oil Type:
Gear oil, typically GL-4 or GL-5 specification, SAE 80W-90 or 85W-140 depending on operating temperature (refer to manual)
Coolant Type:
Ethylene glycol based antifreeze/coolant, mixed with distilled water (typically 50/50 ratio)
Common Wear Items:
Clutch wear, hydraulic pump degradation, injector pump seals, water pump leaks, potential for starter/alternator issues (typical for older heavy machinery)
Electrical Reliability:
Wiring harness degradation over time, requiring inspection and potential repair/replacement.