Category:
Utility All-Terrain Vehicle (ATV)
Target Audience:
Outdoor enthusiasts, farmers, ranchers, recreational riders
Competitors:
Honda FourTrax, Yamaha Kodiak, Polaris Sportsman
Engine Type:
SOHC, liquid-cooled, four-stroke
Drivetrain:
Shaft drive (2WD and 4WD options)
Transmission:
Automatic (CVT-like or clutch-based with hi/low range)
Suspension:
Independent front suspension, Swingarm rear suspension
Engine:
Complete engine overhaul, disassembly, inspection, assembly, torque specifications, timing procedures, valve adjustment, cooling system
Fuel System:
Carburetor service and adjustment, fuel pump, fuel filter, fuel tank, fuel lines
Transmission Drivetrain:
Gearbox, clutch operation, drive shafts, propeller shafts, differential (for 4x4), chain drive maintenance, final drive
Suspension:
Front and rear suspension components, shock absorbers, control arms, wheel bearings, steering knuckle
Brakes:
Hydraulic brake system, brake fluid specifications, master cylinder, brake calipers, brake pads, brake lines, brake pedal, parking brake
Electrical System:
Ignition system, starter motor, charging system (alternator/stator), battery service, lighting, wiring diagrams, fuses, switches, CDI unit
Cooling System:
Radiator service, coolant specifications, fan operation, water pump
Frame Bodywork:
Chassis inspection, frame straightening, body panel removal and installation, seat, fenders, handlebars
Wheels Tires:
Tire pressure specifications, wheel removal and installation, lug nut torque
Maintenance:
Routine maintenance checks, lubrication points, filter replacements, spark plug service, valve clearance checks
Troubleshooting:
Diagnostic charts for common problems, symptom-based troubleshooting guidance
Repair:
Step-by-step repair instructions for all major components and systems
Rebuilds:
Detailed instructions for engine and transmission rebuilds
Overhaul:
Complete disassembly, cleaning, inspection, and reassembly procedures
Adjustments:
Carburetor tuning, ignition timing, brake adjustments, clutch adjustments
Depth:
Full factory repair and service manual covering all aspects of maintenance, diagnosis, and repair
Detail Level:
Highly detailed with specific torque specifications, measurements, and diagrams
Type:
4-stroke, SOHC, single-cylinder
Displacement:
280 cc (approx.)
Bore X Stroke:
72.0 mm x 68.6 mm (typical for this engine family)
Cooling System:
Liquid-cooled
Ignition:
CDI, electronic ignition
Carburetion:
Mikuni carburetor (specific model to be detailed in manual)
Horsepower:
Approx. 18-20 HP (estimated, factory specs vary)
Torque:
Approx. 16-18 lb-ft (estimated)
Fuel Type:
Unleaded gasoline (87 octane or higher)
Fuel Tank Capacity:
Approx. 3.0 - 3.5 gallons (variable by year/submodel)
Type:
Automatic Transmission with Hi/Low range and Reverse
Drive System:
Shaft drive to rear wheels (2WD) or front and rear wheels (4WD)
Clutch:
Automatic centrifugal clutch
Gear Selection:
H (High), L (Low), N (Neutral), R (Reverse)
Differential Lock:
Available on 4x4 models (LT-F300F)
Oil Change:
Every 1000 km or 6 months (refer to manual for precise intervals)
Spark Plug Check:
Every 1000 km or annually
Air Filter Cleaning:
Every 500 km or as needed in dusty conditions
Engine Oil:
SAE 10W-40 API SE, SF, or SG (refer to manual for exact specification)
Engine Oil Capacity:
Approx. 1.9 L (with filter change)
Coolant:
Permanent type antifreeze (50/50 mix with distilled water)
Brake Fluid:
DOT 3 or DOT 4
Carburetor Fouling:
Common issue with older ATVs; regular cleaning and proper fuel storage are key.
Starter Solenoid Failure:
Can occur with age; manual provides testing procedures.
Suspension Wear:
Ball joints, bushings, and tie rod ends can wear with use; manual details replacement.
Drive Shaft Boots:
Can tear, leading to bearing damage; inspection recommended.