Engine Mechanical:
Complete overhaul, internal components, timing, cylinder head, block assembly
Engine Management:
Fuel injection (Motronic), ignition system, sensors, actuators, emissions control
Transmission Manual:
Clutch, gearbox overhaul, shift linkage, hydraulics
Transmission Automatic:
Gearbox overhaul, torque converter, electronic control, hydraulics
Drivetrain:
Driveshafts, differentials, axle shafts, CV joints
Suspension:
Front and rear suspension components, struts, springs, bushings, alignment
Steering:
Power steering system, steering rack, pump, steering column, tie rods
Brakes:
Front and rear disc brakes, ABS system, brake lines, master cylinder, calipers, pads, rotors
Electrical System:
Battery, alternator, starter, lighting, horn, power windows, locks, mirrors
HVAC:
Air conditioning, heating system, blower motor, controls, refrigerant service
Bodywork:
Body panels, doors, hood, trunk, glass, trim, rust prevention
Interior:
Seats, dashboard, trim panels, carpet, headliner
Diagnostics:
Troubleshooting charts, fault codes, diagnostic procedures
Preventative Maintenance:
Oil changes, filter replacements, fluid checks, spark plugs, belts, hoses
Repair Procedures:
Step-by-step instructions for all major systems
Rebuilding Procedures:
Detailed instructions for engine, transmission, and differential rebuilds
Refurbishment Procedures:
Guidance on restoring worn components and systems
Restoration Guidance:
Tips and techniques for returning the vehicle to original specifications
Troubleshooting:
Systematic approach to diagnosing and resolving common and complex issues
Torque Specifications:
Essential torque values for critical fasteners across all systems
Wiring Diagrams:
Detailed electrical schematics for easy diagnosis and repair
Diagnostic Capabilities:
Advanced diagnostic procedures for engine management and ABS
Rebuild Instructions:
Comprehensive rebuild procedures for major mechanical components
Specification Detail:
Highly detailed technical specifications for all vehicle components
Transmission Type:
Getrag 260/5 5-Speed Manual
Transmission Type:
ZF 4HP22 4-Speed Automatic
Transmission Fluid Manual Capacity Quarts:
1.5 (approx.)
Transmission Fluid Automatic Capacity Quarts:
7.0 (approx. total, requires drain and fill)
Transmission Fluid Type Automatic:
Dexron III or equivalent ATF
Rear Axle Ratio:
3.15:1 (typical, check VIN)
Oil Change Interval Miles:
7,500 - 10,000 (synthetic oil)
Spark Plug Replacement Miles:
30,000 - 60,000 (depending on plug type)
Coolant Flush Interval Miles:
24,000 - 36,000
Power Steering Fluid Type:
ATF Dexron II/III or CHF 11S (check reservoir)
Windshield Washer Fluid:
Water-based washer fluid with antifreeze additives (in cold climates)
Common Issue Cooling System:
Plastic coolant expansion tank cracking, water pump failures
Common Issue Fuel System:
Fuel pump failure, clogged injectors
Common Issue Electrical:
Corroded grounds, EPROM failure in ECU, headlight switch issues
Common Issue Suspension:
Worn control arm bushings, strut mounts
Common Issue Interior:
Headliner sagging, door panel adhesive failure
