Engine Mechanical:
Complete overhaul, timing belt/chain, pistons, rings, bearings, cylinder head, valve train, lubrication system.
Fuel System:
Fuel pump, injectors, fuel filter, fuel pressure regulator, tank, lines.
Ignition System:
Spark plugs, ignition coils, distributor (if applicable), timing, wiring.
Cooling System:
Radiator, water pump, thermostat, hoses, coolant specifications.
Exhaust System:
Exhaust manifold, catalytic converter, muffler, pipes, gaskets.
Drivetrain Manual:
Clutch assembly, transmission removal/installation, gear ratios, internal transmission components (limited).
Drivetrain Automatic:
Transmission removal/installation, fluid specifications, torque converter, basic troubleshooting.
Suspension Front:
Struts, springs, control arms, ball joints, bushings, wheel alignment specifications.
Suspension Rear:
Shock absorbers, trailing arms, bushings, wheel alignment specifications.
Steering System:
Steering rack, power steering pump, fluid, tie rods, steering column.
Brake System Front:
Brake pads, rotors, calipers, brake lines, bleeding procedure.
Brake System Rear:
Brake shoes, drums, wheel cylinders, brake lines, bleeding procedure.
Electrical System Lighting:
Headlights, taillights, turn signals, interior lighting, bulb replacement.
Electrical System Charging:
Alternator, battery, voltage regulator, wiring.
Electrical System Starting:
Starter motor, ignition switch, battery connections.
HVAC System:
Heater core, A/C compressor, refrigerant, blower motor, controls, cabin air filter (if applicable).
Body Interior:
Seat removal/installation, trim panel removal, dashboard components.
Body Exterior:
Door panel removal, glass replacement, bumper removal/installation, panel alignment.
Wiring Diagrams:
Comprehensive electrical schematics for various systems.
Scheduled Maintenance:
Oil changes, filter replacements, fluid flushes, tune-ups.
Troubleshooting Diagnostics:
Step-by-step diagnostic procedures for common and uncommon issues.
Component Replacement:
Detailed instructions for replacing most wear items and major components.
Rebuild Procedures:
Instructions for rebuilding key components like engines and transmissions (may be less detailed than dedicated rebuild manuals).
Special Tool Requirements:
Identification of necessary specialized tools for specific repairs.
Depth Of Coverage:
Factory-level detail suitable for professional technicians and advanced DIYers.
Oil Change Interval:
Typically every 5,000 miles (8,000 km) or 6 months, whichever comes first. Consult manual for precise interval and oil type.
Timing Belt Replacement Interval:
Critical item for the G16i engine. Typically every 60,000 - 90,000 miles (96,000 - 144,000 km) or 5-7 years. Failure can cause catastrophic engine damage.
Transmission Fluid Change Interval:
Manual: Check for wear and level. Automatic: Typically 30,000-50,000 miles (48,000-80,000 km) or as per manual. High-stress use may require more frequent changes.
Engine Oil Spec:
API SG/SH or higher. Viscosity typically 10W-30 or 5W-30 depending on climate. Consult manual.
Coolant Spec:
Ethylene glycol based antifreeze/coolant. Typically a 50/50 mix with distilled water. Check manual for specific type and capacity.
Common Wear Items:
Clutch wear, suspension bushings, tie rod ends, exhaust system corrosion.
Electrical Component Reliability:
As with many vehicles of this era, age-related degradation of wiring insulation, sensors, and switches can occur. Alternator and starter motor longevity can vary.
Engine Idling Issues:
Can sometimes be related to vacuum leaks, clogged fuel injectors, or idle air control (IAC) valve issues.