Engine Mechanical:
Engine disassembly, assembly, internal components, timing, seals, gaskets.
Engine Lubrication Cooling:
Oil pump, oil filter, oil pressure, radiator, cooling fan, thermostat, water pump, coolant types.
Engine Fuel Emission:
Fuel injection, carburetion (if applicable), fuel pump, injectors, catalytic converter, EVAP system, emission controls.
Accelerator Control:
Throttle body, accelerator pedal assembly, linkage, cruise control (if equipped).
Fuel Exhaust:
Fuel tank, fuel lines, exhaust manifolds, catalytic converter, mufflers, pipes, oxygen sensors.
Clutch System:
Clutch master cylinder, slave cylinder, clutch pedal, clutch disk, pressure plate, release bearing.
Manual Transmission:
Gearbox overhaul, internal components, shifting mechanisms, fluid specifications.
Automatic Transmission:
Transmission overhaul, valve body, torque converter, electronic controls, fluid specifications.
Propeller Shaft Differential:
Driveshaft U-joints, CV joints, differential carrier, gears, fluid specifications.
Front Rear Axle:
Axle components, bearings, seals, lubrication.
Front Rear Suspension:
MacPherson struts, control arms, bushings, coil springs, shock absorbers, alignment procedures.
Brake System:
Brake pads, rotors, calipers, master cylinder, booster, ABS, brake fluid types, bleeding procedures.
Steering System:
Power steering pump, rack and pinion, steering column, tie rods, alignment.
Restraint System:
Airbag system components, sensors, seat belts, SRS warning light diagnosis.
Body Trim:
Exterior and interior trim removal, panel replacement, door mechanisms, glass replacement.
Heater Air Conditioner:
HVAC system components, refrigerant, compressor, blower motor, climate controls.
Electrical System:
Wiring diagrams, component testing, fuses, relays, battery, charging system, starter, lighting, dashboard instruments.
Maintenance Procedures:
Routine checks, fluid changes, filter replacements, belt adjustments, spark plug replacement.
Diagnostic Procedures:
Troubleshooting guides for common faults, symptom-based diagnosis, diagnostic trouble codes (DTCs).
Repair Procedures:
Step-by-step instructions for component removal, repair, and installation.
Rebuild Procedures:
Detailed instructions for engine, transmission, and component overhauls.
Depth:
Full technician-level detail, equivalent to dealership service manuals.
Scheduled Maintenance:
Detailed schedules for oil changes, filter replacements, timing belt replacement, coolant flushes, and other preventative maintenance tasks are provided.
Engine Oil Grade:
Specific API, ACEA, and SAE viscosity grades for engine oil (e.g., Selenia K Pure Energy 5W-40 for some models, but the manual will specify the exact recommended oil).
Coolant Type:
Type of antifreeze/coolant required (e.g., Paraflu UP, which is an ethylene glycol-based coolant with organic corrosion inhibitors).
Brake Fluid Type:
DOT 3 or DOT 4 brake fluid specification.
Common Faults Diagnostics:
The manual is invaluable for diagnosing common issues such as ignition system problems, sensor failures (e.g., Lambda sensors, Crankshaft Position Sensor), suspension wear, and electrical gremlins. It will guide users on how to address these.