Mazda CX-9 2007-2015 Workshop Repair & Service Manual

Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2007-2015 Mazda CX-9, CX-9 Grand Touring, CX-9 Sport, CX-9 Touring. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2007-2015 Mazda CX-9, CX-9 Grand Touring, CX-9 Sport, CX-9 Touring is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2014 ENGINE Cooling System [MZI-3.7] - CX-9
Engine coolant capacity (approx. quantity) Single fan control module: 12.9 L {13.6 US qt, 11.4 Imp qt}
Dual fan control module: 13.3 L {14.1 US qt, 11.7 Imp qt}
1. Remove the cooling system cap.
2. Remove the radiator drain plug and drain the engine coolant into a container.
3. Flush the cooling system with water until all traces of color are gone.
4. Let the system drain completely.
5. Tighten the radiator drain plug.
Tightening torque 1.5-2.4 N.m {15-25 kgf.cm, 13-21 in.lbf}
6. Referring to the following chart, select the correct volume percentage of the water and engine coolant.
7. Refill the engine coolant into the coolant reserve tank up to the F mark on the tank.
8. Install the cooling system cap.
9. Start the engine and warm up the engine by idling.
10. After the engine warms up, perform the following steps. At this time, be careful of the engine coolant temperature to prevent overheating.
1. Run the engine at approx. 4,000 RPM for 1 min.
2. Run the engine at idle for 1 min.
3. Repeat steps (1), (2) approx. 2 times.
4. Operate the heater at the maximum temperature and airflow, and verify that hot air blows from vent.
11. Stop the engine, and inspect the engine coolant level after the engine coolant temperature decreases. If it is low, repeat steps 7-10.
12. Inspect for engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION [MZI-3.7].)
...