Engine Family:
E-type petrol 4-cylinder, cast-iron block
Engine Codes Covered:
E5F, E6J, E7F, E7J
Engine Type:
Inline 4-cylinder, petrol, cast-iron block
Model Variants:
Clio, Extra, Renault 19, Megane
Production Years Covered:
Refer to the manual's application tables for exact build-date ranges by engine code
Market:
European market Renault passenger cars and light commercial (Extra)
Target Audience:
Professional technicians and DIY owners servicing Renault E-type petrol engines
Purpose:
Workshop-level service, repair and overhaul procedures for E5F, E6J, E7F and E7J engines
Key Advantage:
One manual covering four closely related engine codes used across Clio, Extra, Renault 19 and Megane
Approach:
Component-level procedures with factory-based specifications and torque values
Engine Removal and Installation:
Complete removal and refitting procedures including mounts and connections
Cylinder Head:
Removal, stripping, valve guide and seat inspection, refacing, reassembly
Valve Clearance:
Checking and adjustment procedures and specifications
Camshaft and Timing:
Camshaft removal, timing belt/chain setup, timing marks and tensioning
Cylinder Block:
Strip-down, bore inspection, honing, liner and piston fitment
Pistons and Rings:
Piston and connecting rod servicing, ring end-gap and fitting
Crankshaft and Bearings:
Main and big-end bearing inspection, clearances, end-float checks
Flywheel and Rear Seal:
Flywheel removal, rear main seal replacement
Oil Pump and Sump:
Oil pump inspection, relief valve checks, sump removal and resealing
Fuel System:
Carburettor and petrol injection variants as fitted to E-type engines
Fuel Pump:
Mechanical and electrical pump diagnosis and replacement where applicable
Ignition System:
Distributor, coil, leads, spark plug types and gap settings
Timing Settings:
Static and dynamic ignition timing procedures per engine code
Cooling System:
Water pump, thermostat, radiator, hoses and coolant bleeding
Coolant Specification:
Renault-approved ethylene-glycol coolant; see Maintenance card
Lubrication System:
Oil pump, pressure checks, oil filter and grade recommendations
Engine Management and Electrics
Engine Management:
Sensors, actuators and fault diagnosis for injection-equipped variants
Charging System:
Alternator removal, testing and refitting
Starting System:
Starter motor removal, brush and solenoid checks
Wiring:
Engine harness routing, connectors and earth points
Torque Specifications:
Tightening torques for all major engine fasteners
Capacities:
Engine oil, coolant and gearbox-adjacent fluid capacities where listed
Wear Limits:
Service limits for bores, journals, valves and valve guides
Parts Information:
Component identification and part reference notes for ordering
Technical Depth:
Component-level overhaul procedures with measurements and tolerances
File Format:
PDF (searchable, bookmarked, zoomable)
Compatibility:
Windows, macOS, Linux, iOS, and Android — any device with a PDF reader
Requirements:
A PDF reader application (e.g. Adobe Acrobat Reader, free)
Searchability:
Fully text searchable for fast lookup of any topic
Print Quality:
High-resolution digital pages, printable at full clarity
Binding Type:
N/A — digital download, no physical binding
Paper Type:
N/A — digital download, no physical paper
Engine Family:
Renault E-type, 4-cylinder petrol, cast-iron block
Engine Codes:
E5F, E6J, E7F, E7J
Applications:
Clio, Extra, Renault 19, Megane
Displacement Range:
Approximately 1.2 to 1.4 litres across the E-type family
Valvetrain:
Single overhead camshaft, 8 valves per engine
Fuel System:
Carburettor on early variants, single-point or multi-point petrol injection on later variants
Cooling:
Liquid-cooled, pressurised system
Exact Power and Torque Outputs:
N/A - varies by engine code and tune; see the manual's application tables
Standard Transmission:
Manual transaxle as fitted to Clio, Extra, Renault 19 and Megane models using these engines
Optional Transmission:
N/A - automatic options are model-specific and outside this engine manual's scope
Clutch:
Single dry-plate clutch; removal, inspection and refitting covered in the engine removal section
Drive Configuration:
Front-wheel drive transaxle layout
Exterior and Wheelbase:
N/A - body dimensions vary by model (Clio, Extra, Renault 19, Megane); consult the vehicle-specific body manual
Curb Weight:
N/A - depends on the host vehicle model and trim, not on the engine alone
Engine Mass:
N/A - bare engine weight not stated in the source description
Engine Oil and Filter:
Replace at manufacturer intervals; commonly 10,000 to 15,000 km or annually for these engines
Air Filter:
Inspect and replace at major service intervals
Spark Plugs:
Replace at scheduled intervals; check gap and condition
Timing Belt:
Replacement interval per Renault schedule for the applicable engine code; belt condition should be checked regularly
Coolant:
Check level and concentration; renew at the interval specified for the model
Fluids and Specifications
Engine Oil:
Renault-approved grade; commonly 10W-40 or 15W-40 mineral/semi-synthetic for these engines - confirm against the manual and climate
Coolant:
Ethylene-glycol based, mixed to the correct concentration for the climate
Fuel:
Unleaded petrol, octane rating per the vehicle handbook
Timing Belt and Tensioner:
Wear and tension should be inspected; failure causes serious engine damage
Head Gasket:
Check for coolant loss, overheating and oil contamination
Oil Seals:
Crankshaft front and rear seals and camshaft seals are common leakage points with age
Water Pump:
Bearing noise and seal leaks are typical wear symptoms
Ignition Components:
Distributor cap, rotor arm, leads and plugs degrade with mileage
Engine Mounts:
Rubber mounts perish and cause vibration under load
Brand Heritage:
French manufacturer with a long history of small-capacity four-cylinder petrol engines
Engine Family Role:
The E-type engines powered mass-market Renault models from the late 1980s through the 1990s
Model Evolution:
Used across Clio, Extra, Renault 19 and Megane as Renault's core small petrol units
Production Location:
N/A - plant information is not stated in the source description
